A.1   Messages de l'amorce d'un Linux

Linux version 2.2.17 (root@corn01)
Detected 501135 kHz processor.
Console: colour VGA+ 80x50
Calibrating delay loop... 999.42 BogoMIPS
Memory: 127700k/131008k available
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
CPU: L1 I Cache: 32K  L1 D Cache: 32K
CPU: AMD-K6(tm) 3D processor stepping 0c
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfb4f0
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 131072 bhash 65536)
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
early initialization of device sit0 is deferred
Starting kswapd v 1.5 
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
es1371: version v0.22 time 13:53:12 Oct 26 2000
es1371: found chip, vendor id 0x1274 device id 0x5880 revision 0x02
es1371: found es1371 rev 2 at io 0xe400 irq 10
es1371: features: joystick 0x0
es1371: codec vendor   v (0x838476) revision 9 (0x09)
es1371: codec features 18bit DAC 18bit ADC
es1371: stereo enhancement: SigmaTel SS3D
loop: registered device at major 7
PCI_IDE: unknown IDE controller on PCI bus 00 device 78, VID=10b9, DID=5229
PCI_IDE: not 100% native mode: will probe irqs later
PCI_IDE: simplex device:  DMA disabled
ide0: PCI_IDE Bus-Master DMA disabled (BIOS)
PCI_IDE: simplex device:  DMA disabled
ide1: PCI_IDE Bus-Master DMA disabled (BIOS)
hda: FUJITSU MPF3102AT, ATA DISK drive
hdc: HITACHI DVD-ROM GD-7000, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: FUJITSU MPF3102AT, 9773MB w/512kB Cache, CHS=1245/255/63
hdc: ATAPI 40X DVD-ROM drive, 512kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
DC390: 0 adapters found
scsi : 0 hosts.
scsi : detected total.
rtl8139.c:v1.07 5/6/99 Donald Becker
eth0: SMC1211TX EZCard 10/100 (RealTek RTL8139)
      at 0xe000, IRQ 5, 00:10:b5:86:b6:9d.
Partition check:
 hda: hda1 hda2 hda3 hda4
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 48k freed
Adding Swap: 136544k swap-space (priority -1)
parport0: PC-style at 0x378 (0x778) [SPP,ECP,ECPPS2]
parport0: detected irq 7; use procfs to enable interrupt-driven operation.
ppuser: User-space parallel port driver